ELETOR IC-DC50W24VB

Uninterruptible power supply with the manual and automatic inlet flat opening function . Used to provide security for bred animals, in case of power outage or device failure. The device, after detecting the malfunction, reports the alarm and opens the elevators on the level previously set by the user. Two elevators may be connected to this power supply in an independent way. The device cooperates with all controllers and elevators, controlled with 0-10V signal.

Parameters and features:

• work mode switch: MANUAL or AUTO
• inlet opening level knob
• several work mode signal ranges: 0-10, 2-10, 10-0, 10-2
• inverse control signal option
• NO/NC alarm outputs
• power outage signalling
• 2-10V control voltage monitoring
• 24VDC short circuit output protection
• 0-10V short circuit output protection
• two 0-10V inputs
• two 0-10V outputs
• outputs and inputs electronic security
• 24V 4.0 Ah storage batteries
• IP65 hermetic enclosure
• 85~264VAC 47~63Hz power supply voltage

The UPS has 2 channels that can be merged in the following way:

• chamber piggery – the ups may work for two independent rooms (2 controllers, two actuators)
• smaller feedlots – the UPS may work with one inlet actuator and one damper ( 0-10V inputs, that has to be covered)
• bigger feedlots – the UPS may work with two inlet actuators on each side of the building ( 0-10V inputs, that has to be covered)

In case of using one actuator e.g. EGM-100, EGM-250 or SH24ASR200 connected with the power supply, control 0-10V input – has to be covered, otherwise the UPS activates the alarm

The scheme below presents the way of connecting two EG-100 actuators to the UPS and the alarm control panel

CAUTION! The UPS should be connected to the alarm control panel.

Uninterruptible Power Supply comes with:

• 4 pcs rawlplugs
• 2 pcs 12V 4Ah storage batteries
• 1 pc PG13.5 cable gland
• 3 pcs PG11 cable glands
• 3 pcs PG9 cable glands